GODEX PRINTER DT4 DRIVER
GODEX PRINTER DT4 WINDOWS

Uncheck the box that says 'Use current Printer settings' and then in the Stop position, put in 1.06.

Then go to the 'Stock' tab and to the 'Position Adjustments' at the bottom.The printer takes the exact measurement of the label's dimension and auto - adjusts after performing the self-test on the printer and setting the proper label and printer properties in the QLabel-IV application. On the 'Page Setup' tab, make sure that the Stock is set to 3x2 Godex Label printers work similar like Zebra printers but with a few difference.then go to the 'Advanced' tab and then 'Printer Defaults'.When the test page prints you will hear a cutting noise and the label will fall out of the printer (NOTE the correct orientation of the label is the upper left corner with some of the left and top missing or cut off) Go back to the printer properties box and click the 'Print Test Page' button The printer will spit out some information on the labels.Wait until the printer beeps three times and the light flashes red then release the button.While holding the button turn the power on to the printer.Hold the yellow advance feed button on the lid with the power off.Make sure you have labels in the printer and inserted partway into the exit slot.Select the 'Advanced' tab and click the 'Printing Defaults' button.Click OK to close the Properties window and save the settings.In the next drop-down that appears, select 'After every label,' or 'After Job.' (We recommend 'After Job' as this option results in a single strip of labels per check-in and saves time).Go to the 'Stock' tab and under Media Handling > Post Print Action, select CUT from the first drop-down box (if the printer supports this).(Name it whatever you’d like - Ex: Check-In Labels) In the first tab, at the top, select the 'NEW' button and input 3” for the width and 2” for the height.On the 'General' tab of the printer properties window select 'Preferences.'.Right click on the GoDex printer and select 'Printer Properties.'.On your computer, open the 'Devices and Printers' screen.Next, you'll need to assign the proper label size

GODEX PRINTER DT4 DRIVER

NOTE: Make sure to review your Check-In station settings and select the GoDex printer option that best fits your printer label type.ĭownload the appropriate driver from below for your computer and operating system:ĭT4x (all dark-colored housing) and DT4 (light-colored body with dark lid)

Included are troubleshooting steps if the printer is not out-putting labels properly.

GODEX PRINTER DT4 WINDOWS

Setting Up and Troubleshooting Godex Printer SummaryĪ walkthrough for downloading your GoDex DT4 or DT4x printer driver and the settings to work with check-in on a Windows computer.

Godex printer dt4